Acudor Equipment Access Roof Hatches are designed to provide convenient, economical access to the roof of a building where larger openings are required. This opening allows for equipment to be installed or removed from a building through the roof.
|
CURB ID L&W
|
WEIGHT PER HATCH
|
MODEL
|
inches (mm) |
lbs. (kg.)
|
G6868
|
60 x 60 (1524 x 1524) |
290 (131)
|
Cover
|
Double-skin construction (“in box type design”) with 1" cellulose insulation and a continuous EPDM foam weather/draft seal gasket that is attached to the inside of cover to provide a flush, tight fit. Designed to support a live load of 40lbs./sq. ft., the cover is 14 gauge galvanized steel with a 22 gauge galvanized steel inside liner.
|
Curb
|
14 gauge galvanized steel with 1" thick fiberboard roof insulation at curb exterior. Curb is 12" high, with 3.375" wide bottom flange and pre-drilled mounting holes.
|
Hinge Pin
|
Heavy duty galvanized steel pintle hinges with 3/8" pin |
Opening
|
Gas spring operators allow cover to open and close with ease. Inside pull handle allows for easy control when closing cover.
|
Door Latch
|
Self latching, zinc plated outside T handle with stainless steel inside lock and lever assembly. Unit also has inside and outside padlock provisions.
|
Finish
|
Material is prepared with an iron phosphate wash, followed by a rust inhibiting primer, and then a baked on polyester enamel paint.
|
SHIPPING: | 5-6 Weeks |
---|---|
MATERIAL: | Galvanized Steel |
ACCESS TYPE: | Equipment |